Introduction to ntopng
Routers show connected devices but don't reveal their activities. ntopng, a free tool, offers a comprehensive view of network traffic. This guide walks you through setting up ntopng on a supported Linux distribution.
To install ntopng, you need to run a few commands. First, update your system with sudo apt update. Then, identify the Wi-Fi interface you want to monitor (e.
Configure ntopng by editing the configuration file /etc/ntopng/ntopng. Add the identified Wi-Fi interface (e. Optionally, set custom ports for HTTP and HTTPS (e., -w=3013 and -W=3014`).
After configuring, restart the ntopng service with sudo systemctl restart ntopng. Access the dashboard at http://localhost:3000 using admin / admin credentials. You can change the port if needed.
Exploring the Dashboard
Once ntopng is running, the dashboard will display live traffic. The Top Flow Talkers chart and Top Applications breakdown will show you the most active devices and applications. The Hosts page will list detected devices, and the MAC List will show manufacturer information.
Expanding Your View
To see traffic from other devices, you need to install ntopng on a firewall or a managed switch. The cleanest setup is to run ntopng on a firewall like OPNsense or pfSense, where all traffic passes through by default. However, this isn't possible on most ISP-supplied routers.
Practical Uses
ntopng can be a valuable tool for identifying devices that are active even when they appear to be idle. It can also help you troubleshoot network issues and understand the true capabilities of privacy-friendly gadgets. The free Community edition is suitable for small networks, like home setups.
Conclusion
ntopng is a powerful tool for gaining real-time insights into your network traffic. By following this guide, you can set up ntopng quickly and start uncovering the activities of your connected devices and applications.

Comments